HP StorageWorks 1510i Modular Smart Array - Manual (Page 37)

4. Select IP Address > Create Portal.
5. Enter settings for the portal.
NOTE:
For additional security, do not use commonly-known TCP ports.
6. When the display refreshes, verify that the newly configured portal is shown in the component list.
7. As needed for your environment, repeat Step 4 through Step 6 to assign additional TCP ports to
this IP address.
8. Repeat Step 1 through Step 7 to add additional IP addresses to this data port or to configure the
remaining data ports, such as SA1, SB0, and SB1.
Sample configuration status - after configuring management and data ports
Figure 10 illustrates the current configuration.
The following items are configured:
• Management port MA0 and MB0
• Data ports SA0, SA1, SB0, and SB1
• Each data port is assigned two (2) IP addresses
• Each IP address is assigned two (2) TCP portals
HP Storage Management Utility user guide 37