HP StorageWorks 1510i Modular Smart Array User Manual

Page 16

Wait a few moments for the utility to load.

NOTE:

When accessing the SMU for the first time, a window is displayed requiring input of a

user-defined username and password.

One of the following happens:
• If key components of the system are unconfigured, a prompt to go to the Wizard tab is

displayed. (For more information, see “

• If the system is partially configured, the Configure tab is displayed. (For more information,

see “

• If the system is configured, the View tab is displayed. (For more information, see

Changing the management port IP address through the

MSA1510i controller display panel

When the MSA1510i is initially installed and powered on, an IP address is automatically assigned to

the primary management port (usually MA0). Depending on your network configuration, this default IP

address may not be accessible by the network servers.
To change the IP address of the MSA1510i management port to be in the same LAN segment as the

network servers, do the following:

Access the controller LCD panel management menu. Press the right (>) navigation button on the

front of the active controller (usually the front-right controller.) Network Settings should be displayed

and blinking.
LCD panel navigation buttons work as follows:

Navigation button

In the menu

Within a menu option

Right (>)

Select a blinking menu option.

When changing IP address

settings, move to the next digit.

Up/Down (^/v)

Scroll through the menu options.

Change/Toggle a setting.

Left (<)

Not applicable.

Accept the displayed setting and

return to the initial management

menu display.

Overview