HP StorageWorks 1510i Modular Smart Array - Manual (Page 52)

2. Select Target > Enable/Disable Access Control.
3. Expand the ACL State drop-down box, and enable access control.
4. The following warning message is displayed:
5. Confirm that there is no active I/O on the target, and then click OK.
IMPORTANT:
• To prevent loss of access to the storage, ACLs should not be modified if there is an active
session between the initiator and the target. Before enabling ACL for a target, open
your iSCSI initiator software and verify that the target status is inactive or disconnected.
• When access control is disabled (default), all initiators with access to the array controller
can access the storage targets. (If CHAP authentication is set up, only initiators with
verified CHAP secrets can access the storage.)
• When access control is enabled , access to all mapped logical drives of the target is
immediately blocked ( Step 2 through Step 3 ), until ACLs are created for each mapped
logical drive ( Step 6 through Step 7 ).
52 Configure