HP StorageWorks 1510i Modular Smart Array - Manual (Page 50)

2. Enter the requested information for the iSCSI initiator.
NOTE:
•
The iSCSI Initiator Name is assigned when defining the initiator on the server, and is usually in the
format of “iqn.xxx”. Obtain initiator names from your network administrator or as displayed in the
iSCSI initiator software on the server.
• Be sure to enter the iSCSI Initiator Name exactly as assigned in the iSCSI initiator software on the
server. Include all special characters, including periods, and spaces. If the initiator name is entered
incorrectly, the target cannot be presented to the initiator.
• The system suggests a default value for the iSCSI Initiator Name Alias. Accept the default or enter a
user-defined, descriptive value.
• Expand the iSCSI Initiator Profile Name drop-down box to identify the operating system of this
initiator.
Configuration status - after adding initiators
Figure 13 illustrates a completed configuration:
• Management port MA0 and MB0
• Data ports SA0, SA1, SB0, and SB1
• Physical hard drives, into arrays and logical drives
• Targets
• Initiators
• Initiator 1
• Initiator 2
• Initiator 3
50 Configure