HP StorageWorks 1510i Modular Smart Array - Manual (Page 63)

1. Select Storage System > Clear Configuration.
2. Select the configuration components to clear.
NOTE:
• Select all—Clears all iSCSI, storage, and management configuration settings.
• iSCSI Configuration—Clears iSCSI configuration settings only.
• Management Configuration—Clears management configuration settings only.
• Storage Configuration—Clears storage configuration settings only.
• When management settings are cleared, any changes to the management port IP
address are erased and a new IP address is assigned to the management port. To obtain
the new IP address, press the arrow buttons on the front of the array controller and scroll
through the LCD messages until the following message is displayed: 603 Port MA0
IP <address>. Record the new IP address, so that you can again access the SMU.
3. A warning message is displayed. Review the selected options and respond appropriately.
Deleting a component (Delete)
If necessary, the following components can be deleted:
• Arrays
• Logical drives
• Targets
• Mapped logical drives
• Initiators
• Data port IP addresses
• IP address portals
• Routes
• Target portal groups
To delete a component, select the component from the list, and then select Delete from the task list.
HP Storage Management Utility user guide 63