Set radius pollsec, Enable ntp, Set ntp server – HP ProLiant SL2500 Scalable System User Manual
Page 94: Set ntp poll, Show ntp server
CLI commands 94
SET RADIUS POLLNUM
•
Description:
Number of times HP APM polls each of the radius server indicated in the ADD RADIUS SERVER
command. This setting can only be set globally and cannot be applied to each individual RADIUS
server.
Set RADIUS pollsec
•
Command:
SET RADIUS POLLSEC
•
Description:
Number of seconds HP APM waits for a reply from the RADIUS server. This setting can only be set
globally and cannot be applied to each individual radius server.
Enable NTP
•
Command:
ENABLE NTP
•
Description:
Enables NTP operation. At least one NTP server must be configured before operation.
Set NTP server
•
Command:
SET NTP SERVER NONE|
•
Description:
Sets the NTP server to retrieve the time from using the configured polling cycle.
Set NTP poll
•
Command:
SET NTP POLL
•
Description:
Sets the time in minutes to poll for time from the configured NTP server.
Show NTP server
•
Command:
SHOW NTP SERVER NONE|
•
Description:
Indicates the NTP server to retrieve the time from using the configured polling cycle.