Disable password, Enable password, Set password account – HP ProLiant SL2500 Scalable System User Manual
Page 77
CLI commands 77
NOTE:
Only an Administrator can add or enable a new user account.
•
Command:
ADD ACCOUNT "
•
Description:
o
Adds a new user to the system.
o
A single HP APM is capable of supporting up to 10 added accounts. The built-in Administrator
account is the default and cannot be deleted.
o
All user accounts have the same permissions.
o
Each user account has its own login credentials.
—
After a command is entered with a valid username, you are prompted to enter a password for
the new account. After the completion of the password entry, the new account is available for
logging into the system.
—
If the password field is not specified, then the password appears after this command is entered
and the username does not already exist.
o
Login accounts and passwords are stored separately from the board configuration. A SHOW
CONFIG command does not reveal any ADD ACCOUNT commands.
Disable password
•
Command:
DISABLE PASSWORD
•
Description:
Disables the password protection feature. Disabling password protection also disables SSH and Telnet
network access.
Enable password
•
Command:
ENABLE PASSWORD
•
Description:
Enables the password protection feature. SSH and Telnet access requires the password feature to be
enabled.
Set password account
•
Command:
SET PASSWORD
SET PASSWORD "
SET PASSWORD ACCOUNT "
SET PASSWORD ACCOUNT "