Security configuration, Protocol configuration, Working with ssh configuration – HP ProLiant SL2500 Scalable System User Manual
Page 23: Working with the telnet configuration, Duplicating the configuration
Installation and configuration 23
Security configuration
The network interface is disabled when password protection is removed. For more information about
passwords, see "Working with passwords (on page
)".
Protocol configuration
HP APM supports SSH and Telnet.
Working with SSH configuration
To enable SSH access, enter ENABLE SSH.
To disable SSH access, enter DISABLE SSH.
Working with the Telnet configuration
To enable Telnet access, enter ENABLE TELNET.
To disable Telnet, enter DISABLE TELNET.
Duplicating the configuration
Duplicating a configuration enables you to ensure consistency in configuring HP APM while saving time in
the configuration process.
You can use the output from SHOW CONFIG to capture the current configuration of a HP APM and used as
input to configure another HP APM. The password information is not duplicated because it is not part of the
SHOW CONFIG output.
To duplicate the HP APM configuration:
1.
Enter SHOW CONFIG.
2.
To copy the configuration, copy the output of the SHOW CONFIG command to a file on your system using
whatever methods are available in your terminal program.
3.
To replicate the configuration, using the methods that are available in your terminal program, apply the
previously saved SHOW CONFIG output as input to the new HP APM.