Exiting, logging out, or quitting hp apm, Connecting and setting ports – HP ProLiant SL2500 Scalable System User Manual
Page 63
General commands 63
All configuration and password settings will be lost. Password access will be disabled. Network access will
be prevented due to disabled password.
Exiting, logging out, or quitting HP APM
To exit enter one of the following: EXIT, LOGOUT, enter QUIT.
Connecting and setting ports
To connect the current CLI session to the specified serial port, enter CONNECT PORT.
To configure a single or all serial ports, enter SET PORT.
Ports 1 through 10 refer to the display ports, and 11 and 12 refer to the serial ports.
This is an example of setting port to 115200 baud rate with 8N1:
myslapm> set port 1 115200 8N1
Serial Port 1 set to 115200 bps, 8N1
This is an example of setting all ports to 115200 baud rate with 8N1:
myslapm> set port all 115200 8N1
Serial Port 1 set to 115200 bps, 8N1
Serial Port 2 set to 115200 bps, 8N1
Serial Port 3 set to 115200 bps, 8N1
Serial Port 4 set to 115200 bps, 8N1
Serial Port 5 set to 115200 bps, 8N1
Serial Port 6 set to 115200 bps, 8N1
Serial Port 7 set to 115200 bps, 8N1
Serial Port 8 set to 115200 bps, 8N1
Serial Port 9 set to 115200 bps, 8N1
Serial Port 10 set to 115200 bps, 8N1
Serial Port 11 set to 115200 bps, 8N1
Serial Port 12 set to 115200 bps, 8N1