HP ProLiant SL2500 Scalable System - Manual (Page 36)

Logging 36
Fault logged message Description
Fans:
• Power Manager Fan 2, failed
• Both fans failed
• One or more Fan rotor(s) failed
• One or more Fan(s) failed
• One or more Fan health status
improved
Fans failed or removed.
There is a 20 second delay in detecting a fan status change.
User config corruption detected, using
backup copy. The user configuration is corrupted, and HP APM is using the backup
copy.
Remove all accounts, and then add a new account and password.
User config settings lost due to corruption,
please contact HP support. The user configuration is corrupted, and the backup is corrupted as
well.
Remove all accounts and then add a new account and password.
Baseline config corruption detected, using
backup copy. There was a corruption on baseline config, and HP APM is using the
backup copy.
Use CLI command “Show power baseline” to determine if it’s still the
correct baseline. If it is not, then remove the power cap, and if
needed, use CLI command “Set power baseline."
Baseline config settings lost due to
corruption, please contact HP support. There is no power baseline set.
Use CLI command “Set power baseline."
Key corruption detected, using backup
copy.
There is an key corruption, and HP APM is using the backup copy.
Use CLI command “Disable xml”, if it’s enabled, and shutdown all
SSH sessions. Use CLI command “Reset keys.”
Power cap config corruption detected,
using backup copy.
The power cap is corrupted, and HP APM is using the backup copy.
Use CLI commands “Show power cap” and “Show power baseline”
to verify that the power cap is in the set correctly. If not, use the CLI
command “Set power baseline” and “Set power cap.”
Power cap config settings lost due to
corruption, please contact HP support.
The power cap configuration is corrupted, and the backup is
corrupted as well.
Use CLI commands “Show power cap” and “Show power baseline”
to verify that the power cap is in the set correctly. If not, use the CLI
command “Set power baseline” and “Set power cap.”
Config corruption detected, using backup
copy.
The configuration is corrupted, and HP APM is using the backup
copy.
Use CLI command “Config,” or set the individual config item and
save again.
Config settings lost due to corruption,
please contact HP support.
The configuration is corrupted, and the backup is corrupted as well.
Use CLI command “Config,” or set the individual config item and
save again.
Zone config corruption detected, using
backup copy.
The zone configuration is corrupted, and HP APM is using the backup
copy.
Use CLI command “Show zones” and verify if the backup copy is
sufficient. If not, add the zones as needed.
Zone config settings lost due to
corruption, please contact HP support. The zone configuration is corrupted, and the backup is corrupted as
well.
Use CLI command “Show zones” and verify if the backup copy is
sufficient. If not, add the zones as needed.
Timeout waiting for chassis response.
The chassis failed to respond to the requested command.