HP ProLiant SL2500 Scalable System - Manual (Page 62)

General commands 62
For example, the following text appears:
APM-D4C9EFCB00B4> show version
HP Advanced Power Manager
(c) Copyright 2014 Hewlett-Packard Development Company, L.P.
All rights reserved
Version 2.00
Build time was Apr 21 2014, 11:58:04
To show the HP Power Management Controller Utility hardware and firmware versions as well as the license
status of all servers in the enclosures, enter SHOW VERSION ALL.
Rebooting and resetting factory settings
To reboot, enter REBOOT. Unsaved configuration settings are lost.
Rebooting the HP Moonshot 1500 Chassis CM
module
To reboot the HP Moonshot 1500 Chassis CM module, enter REBOOT CM .
where:
refers to the HP APM port.
refers to the HP APM Distribution Module port.
Performing a reset
To reset, enter RESET. Unsaved configuration settings are lost.
Performing a reset buddy
To reset or reboot the other HP APM module (the Buddy, if connected), enter RESET BUDDY.
For more information, see the redundant reset in "HP APM rear view (on page
11 )."
Clearing the screen
To clear the session screen, CLEAR SCREEN.
Resetting factory settings
NOTE: This command can only be run from the serial console.
To reset the factory settings, enter RESET FACTORY.