HP ProLiant SL2500 Scalable System - Manual (Page 58)

General commands 58
Removing zones
To remove one or more chassis from a zone definition, enter
REMOVE ZONE [[ ]] | [ ALL] | [ALL]
where:
• is the zone name.
• is the port number.
• is the distribution module port number.
• is the port number.
If no more chassis exist in the zone after the target chassis is removed, then the zone is automatically deleted.
The syntax for indication which chassis is to be removed is identical to the ADD ZONE command.
For example:
REMOVE ZONE my_zone ALL
Removes all chassis from the zone MY_ZONE. This command also deletes the zone definition of MY_ZONE
because no chassis is associated with it.
REMOVE ZONE my_zone 1 ALL
Removes all chassis plugged into the HP APM Distribution Module on APM port 1.
Showing zones
To display all the currently defined zones and their respective member chassis, enter SHOW ZONES.
For example:
myslapm> show zones
Zone BLUE:
Power Manager port 1:
all Dist. Module ports included
Zone RED:
Power Manager port 1:
Dist. Module port 2
myslapm>
Saving zones
To commit the defined zones and their member chassis to the on-board EEPROM, enter SAVE ZONES.
You can define and save up to four zones. These zones are automatically loaded from the EEPROM when the
board is reset.
Using password recovery
HP APM has a password recovery mechanism through the reset switch. If you press the reset switch for more
than 5 seconds, the board reboots and proceeds in the password recovery mode. In the password recovery
mode, the board boots up without asking for a password. All network interface is disabled.