HP ProLiant SL2500 Scalable System - Manual (Page 65)

Using SNMP 65
Setting the SNMP read-only community string
To set the SNMP read-only community string, enter SET SNMP RO "". For example,
enter:
SET SNMP RO "alphabravo"
Setting the SNMP read-write community string
To set the SNMP read-write community string, enter SET SNMP RW "". For
example, enter:
SET SNMP RW "alphabravo"
Setting the SNMP contact
To set the sysContact field, enter SET SNMP CONTACT "". For example, enter:
SET SNMP CONTACT "alphabravo"
Setting the SNMP location
To set the sysLocation field, enter SET SNMP LOCATION "". For example, enter:
SET SNMP LOCATION "alphabravo"
Setting SNMP trap destinations
To set the IP address for SNMP traps, enter SET SNMP TRAPDEST <|NONE>. For
example, enter:
SET SNMP TRAPDEST x.x.x.x
You can set up to four SNMP traps at once. For example, enter:
SET SNMP TRAPDEST x.x.x.x y.y.y.y z.z.z.z a.a.a.a
If you specify NONE, then no traps are set. For example, enter:
SET SNMP TRAPDEST NONE
HP APM supports the following SNMP traps:
• cpqRackNameChanged
• cpqRackEnclosureRemoved
• cpqRackEnclosureInserted
• cpqRackEnclosureFanRemoved *
• cpqRackEnclosureFanInserted *
• cpqRackEnclosureFanFailed
• cpqRackEnclosureFanOK
• cpqRackPowerSupplyFailed