HP Remote Device Access Software - Manual (Page 27)

5. Enter values in the Network Configuration and the NTP Servers fields. The Network Configuration
and the NTP Servers fields are required fields. If you are unsure of the correct values, then contact
your network administrator.
When you change the administrator password, a message appears informing you that you need to log
on again. When you change the IP address of the vCAS, a message appears informing you a
countdown to an automatic redirect of your browser to the new vCAS address begins.
6. When the countdown reaches zero, your browser is automatically redirected to the new vCAS
address. Your vCAS is now ready for use and the main vCAS control panel appears.
Initial configuration is complete. To edit the configuration parameters, select Tools, and then Setup
from the main menu.
Add the Virtual CAS to the RAP
A Virtual CAS (vCAS) is treated as another SSH Direct CAS, but for it to work correctly, the Type,
Authentication Methods and the Login Methods must be set correctly.
Add your vCAS to the RCTS through the New Order process or add it to an existing order. In both cases
you end up with a CAS with default settings. Make the following changes to make sure that you can
connect to the CAS (as shown in
"Figure 3.1 CAS Configuration in the RCTS" .
HP Remote Device Access 8.1: vCAS User Guide Page 27 of 65
Chapter 3: Configuring Your vCAS