HP Netserver E Server series - Manual (Page 58)

Chapter 6 Installing an Additional Processor
52
1. Disconnect the cooling fan connector from its respective cooling fan
connector on the system board. See Figure 6-1.
2. Unhook the thumb latch on the heatsink and lift the heat sink up slightly
from the processor. See Figure 6-5.
3. Rotate the heatsink away from the processor toward the rear of the
NetServer, releasing the hook latch.
4. Lift the heatsink away from the processor and out of the NetServer.
5. Open the ZIF lever to allow removal of the processor. See Figure 6-4.
6. Grasp the processor by its edges and lift it out of the socket and place it on
a static-dissipating work surface or into an anti-static bag.
7. If you are not replacing the processor with a new or replacement processor,
you must install the terminator in the empty processor socket. See Figure
6-3.