HP Netserver E Server series - Manual (Page 24)

Chapter 3 Installing Mass Storage Devices
18
Shelf 1
Shelf 2
Shelf 3
Captive
Screws (3)
Shelves 4-7(4)
Latch Opening
Air Duct
Latch
Cable Clamp
Channel B Channel A
Figure 3-1. Moving the Air Duct
CAUTION Install and remove connectors carefully, and avoid displacing
any of the pins.
6. Unplug the power and SCSI cables to any hard disk drives already in the
drive cage.
If necessary, disconnect the SCSI cable from the cable clamp on the
underside of the drive cage to free the drive cage. See Figure 3-1.
7. Loosen the three captive screws on the hard disk drive cage.
See Figure 3-1.
8. Remove the hard disk drive cage from the chassis. See Figure 3-2.
NOTE If the hard disk drive you are planning to install already has a
mounting tray attached, you must remove it before you can
install the drive in the HP NetServer.
9. Slide the drive into the available cage opening with the cable connectors
toward the rear of the NetServer. See Figures 3-2 and 3-3.