HP Netserver E Server series - Manual (Page 41)

35
5 Installing Additional Boards
Introduction
The system board in the HP NetServer E 800 provides up to seven PCI slots
(P1 through P7), with five 32-bits slots and two 64-bit slots.
Tested PCI Boards
For a list of tested PCI boards, check for compatibility in Configuration Assistant
on the Navigator CD-ROM or look for the Hardware Tested Products list for the
HP NetServer E 800 under the Service and Support topic for the specific NOS
used in the NetServer at HP’s web site:
http://www.hp.com/netserver/support/
CAUTION Some accessory board outputs may exceed U.S. National
Electrical code (NFPA 70) Class 2 or limited power source
limits and must use appropriate interconnecting cabling in
accordance with the National Electrical Code. (All
Hewlett-Packard boards comply with Class 2.)
Also refer to the Readme file and Configuration Advisor on your HP NetServer
Navigator CD-ROM. Refer to Chapter 8, "Configuring the HP NetServer," for
instructions.
Tools Required
The tools used to remove or add accessory boards in the NetServer include:
•
Torx T-15 screwdriver
•
¼-inch flat blade screwdriver
•
An anti-static service kit (3M 8501/8502/8503 or equivalent). This kit
includes a static-dissipating work surface, a chassis clip lead, and a wrist
strap.