HP Netserver E Server series - Manual (Page 15)

9
2 Opening and Closing the HP
NetServer
Introduction
This chapter describes how to remove and replace the HP NetServer’s main cover
and adjust the stabilizing feet on the bottom of the chassis.
WARNING Before removing the cover, always disconnect the power cord
and unplug telephone cables. Disconnect the power cord to
avoid exposure to high energy levels that may cause burns
when parts are short-circuited by metal objects such as tools
or jewelry. Disconnect telephone cables to avoid exposure to
shock hazard from telephone ringing voltages.
Tools Required
The following tools may be required to remove and replace the cover.
•
Torx T-15 driver
•
¼-inch flat blade screwdriver
Removing the Cover
To remove the cover, follow these steps:
NOTE These steps do not include the removal of the front bezel of the
NetServer. You do not need to remove the front bezel of the
HP NetServer E 800 to install internal accessories, such as
memory or mass storage.
1. Turn off the NetServer and disconnect the power cord and any phone line.
2. Unlock the cover by using the key in the key bag located on the rear of the
NetServer.
The locking mechanism is at the rear. See Figure 2-1.
3. Remove six (6) T-15/slotted thumbscrews. See Figure 2-1.