HP Netserver E Server series - Manual (Page 34)

Chapter 4 Installing Additional Memory
28
•
Supported memory capacity ranges from 128 MB to 2 GB maximum (512
MB per DIMM slot x 4 DIMM slots total). The minimum capacity is 128
MB (one DIMM).
•
DIMM sizes may be mixed on the system board and may be loaded in any
order (0 through 3).
However, HP recommends starting at slot 0 and filling the slots in order
with the largest size first: 0, 1, 2, and 3.
•
Open slots between DIMMs are permitted.
•
When handling DIMMs, observe anti-static precautions to avoid damage.
Installing Additional DIMMs
1. If the system is already installed and working, power down the system.
Refer to Chapter 1, "Controls, Ports, and Indicators."
2. Disconnect the power cables and any external cables connected to the
system.
If necessary, label each one to expedite re-assembly.
3. Remove the cover and turn in the chassis feet inward to lay the chassis flat
on its side.
Refer to Chapter 2, "Opening and Closing the HP NetServer."
WARNING The power supply will continue to provide standby current to
the NetServer E 800 until the power cable is disconnected.
4. Lay the NetServer on its side (components showing).
5. Unsnap the air duct and move it out of the way. See Figure 4-1.