HP Netserver E Server series - Manual (Page 31)

Chapter 3 Installing Mass Storage Devices
25
2. Using a flat blade screwdriver, pop out the external SCSI knock-out at the
connector location shown on the rear of the NetServer. See Figure 3-8.
Figure 3-8. Connecting the Cable to the Rear of the NetServer
3. Thread the cable from the SCSI channel B connector, along the bottom
edge of the chassis toward the rear of the chassis. See Figure 3-9.
4. Place the folds in the cable along the rear of the chassis and thread the
remainder over the existing PCI boards to the knockout location.
5. Install the external connector end of the cable into the knockout opening in
rear of the chassis and insert the two threaded studs from the outside.
See Figures 3-8 and 3-9.