HP OneView for VMware vCenter - Manual (Page 14)

6. Select the Full Access check box for one or more storage pools to enable provisioning by the
Storage Module for vCenter.
If you will not perform provisioning operations on a particular storage pool, you do not need
to enable Full Access for that storage pool.
7. Click Finish.
The management server and all of the selected arrays are added to the Configured Arrays
and Management Servers list.
Adding HP P6000 EVAs
To view information about a P6000 EVA, use the Storage Administrator Portal to add the array
and associate it with a P6000 Command View management server. During the initial Storage
Module for vCenter configuration, add the P6000 EVAs and P6000 Command View management
servers in a single step as described in
“Adding HP P6000 Command View management servers”
(page 13) . After the initial configuration, you can add and remove P6000 EVA and management
server associations by modifying the configuration for either the P6000 Command View management
server or the P6000 EVA.
NOTE: With the release of the P6300/P6500 EVA, the EVA family name has been rebranded
to HP P6000 EVA. The names for earlier EVA models did not change. For the supported P6000
EVA models, see the HP SPOCK website:
http://www.hp.com/storage/spock .
To add P6000 EVAs:
1.
Log in to the Storage Administrator Portal.
For instructions, see “About the Storage Administrator Portal” (page 10) .
2. Click Add.
The Add Storage Array or Management Server (1 of ...) page appears.
3. Select HP P6000 EVA in the Type list, and then click Next.
The Add HP P6000 EVA (2 of 3) page appears. The Array Name list shows all available
P6000 EVAs. The Available P6000 Command View servers box shows all configured P6000
Command View servers that manage the selected P6000 EVA. The Selected P6000 Command
View servers box shows all P6000 Command View servers that the Storage Module for vCenter
can use to manage the selected P6000 EVA.
4. Select the array that you want to manage.
5. To add a P6000 Command View server, select one or more available servers, and then click
Add.
To remove a server, select one or more servers, and then click Remove.
NOTE: The list of available servers includes only P6000 Command View management
servers that were added using the procedure “Adding HP P6000 Command View management
servers” (page 13) .
TIP: Click Add All or Remove All, respectively, to add or remove all P6000 Command View
servers.
6. Click Next.
The Add P6000 EVA (3 of 3) page appears, listing the storage pools on the selected P6000
EVA.
14 Configuring Insight Control for vCenter