HP OneView for VMware vCenter - Manual (Page 66)

4 Provisioning storage
The Storage Module for vCenter supports storage provisioning for 3PAR, P4000, P6000 EVA, and
P2000 G3 MSA arrays. You can perform storage provisioning operations such as adding a new
datastore, deleting or expanding an existing datastore, creating new VMs, or cloning existing
VMs.
For P6000 EVAs, provisioning operations are supported for thick-provisioned virtual disks. If a
datastore, RDM, or VM was created on a thin-provisioned virtual disk outside of the Storage Module
for vCenter, it can be cloned to a thick-provisioned virtual disk.
To perform the tasks in this chapter, you must do the following:
•
Use an HP array that supports provisioning.
•
Use the Storage Administrator Portal to set the Full Access permission for the storage pools
you want to use. For more information, see
“About the Storage Administrator Portal” (page 10) .
•
Disable the browser pop-up blocker. If the pop-up blocker is enabled, you cannot start a
provisioning procedure by right-clicking a VM, host, cluster, or datastore in the inventory tree.
•
Use a cluster with configured hosts when performing provisioning operations on a cluster.
TIP: By default, Internet Explorer shows the page URL in the title bar of a pop-up browser window.
To show the window title, enable the following Internet Explorer security settings:
•
Allow script-initiated windows without size or position constraints
•
Allow websites to open windows without address or status bars
Customizing the location of virtual disks on a P6000 EVA
Before performing provisioning operations on P6000 EVAs, you might want to change the folder
in which your virtual disk is created.
When you create a datastore on a P6000 EVA using the Storage Module for vCenter, by default,
the associated virtual disks are created at the root level of the Virtual Disks folder. You can
customize the location of the virtual disks by modifying the configuration.xml file, which is
located in the following directory:
install folder\Storage\JBoss\standalone\configuration
Changing the default location for all P6000 EVAs
To change the default location for all P6000 EVAs, modify the value \Virtual Disks\ in the
following section of the configuration.xml file:
\Virtual Disks\
Changing the default location for a specific P6000 EVA
To change the default location for a specific P6000 EVA, add the following text to the
configuration.xml
file:
\Virtual Disks\FolderName
Use ArrayName to specify an array, and FolderName to specify the virtual disk location.
NOTE: FolderName must exist on the P6000 EVA, or provisioning operations will fail.
66 Provisioning storage