HP D2D100 Backup System - Manual (Page 72)

Network configuration
The details in this section reflect the IP settings that were specified during installation. The HP D2D Backup
System supports DHCP and this is turned on by default.
You may need to edit the details if there is a conflict in the IP address, or you move the host to a different
network node. Be aware that any changes you make to the network settings could affect how you
connect again to the HP D2D Backup System. For example, if you change the IP address, you must use
the new address to log in from a web browser.
To edit network settings
1. Click Edit to make the details editable.
2. Make the required changes and click Update.
3. You must now reconnect to the HP D2D Backup System using the new settings.
• If you have changed the IP address, you must use the new address to log in from a web
browser.
• You will also need to edit the iSCSI Initiator on all hosts that are connected to the HP D2D
Backup System, if you change the IP address. See “ The iSCSI Initiator ” on page 47.
72 The Web Management Interface