5 advanced installation, Using dhcp to discover the hp d2d backup system, Advanced installation – HP D2D100 Backup System User Manual
Page 45

5 Advanced installation
Although the Installation wizard is the recommended way to install the HP D2D Backup System, it is
possible to install it manually. You may also need to run phases independently when troubleshooting.
This chapter describes:
•
Using DHCP to discover the HP D2D
•
Using the Discovery Engine to discover the HP D2D
•
•
•
Using DHCP to discover the HP D2D Backup System
If you are connecting the HP D2D Backup System to a network that has a DHCP server, DHCP addressing
is enabled by default. The IP address and other network settings are assigned automatically when you
connect the HP D2D Backup System to the network. You only need to know the name of the HP D2D
Backup System to complete the installation and create an 8–slot autoloader configuration. The name is in
the format D2DBS-
In the web browser type in: D2DBS-
NOTE:
Depending on network settings, you may need to enter the full domain path.
Once the HP D2D Backup System has been discovered on the network, you must configure the Microsoft
iSCSI Initiator on the host, so that the autoloader devices on the HP D2D are visible to the backup
application. See “
Using the Discovery Engine to discover the HP D2D Backup
System
If your network does not have a DHCP server, the Discovery Engine allows you to locate the HP
D2D Backup System on your network and assign network settings, such as the IP address. It is the
recommended way to locate and configure the HP D2D Backup System on your network, if you are
using static IP addressing. It also allows you to select your required base configuration and specify
the number of slots for an autoloader.
The Discovery Engine can be run as part of the Installation wizard or as a standalone utility from the HP
StorageWorks Tape CD-ROM.
D2D Backup System
45