beautypg.com

Installing the hba, 12 removing the front bezel, 13 removing the slot cover retainer – HP D2D100 Backup System User Manual

Page 31

background image

Figure 12 Removing the front bezel

Installing the HBA

CAUTION:

Static electricity can damage electronic components. Always wear an antistatic wriststrap if one is

available. If not, after you have disconnected power from the server and removed the cover, touch a bare

metal part of the chassis. Similarly, touch a bare metal part of the drive before installing it.

The supported PCI-Express HBA should be installed in the top PCI slot. Please refer to

www.hp.com/go/connect

for a list of all supported host bus adapters and tape drives. No additional

drivers are required for recommended HBAs and tape drives; they are included in the HP D2D Backup

System firmware.

1.

Undo the retaining screw (1) and remove the slot cover retainer (2).

Figure 13 Removing the slot cover retainer

2.

Remove the cover from the top expansion slot.

D2D Backup System

31