45 removing the hard drive, 119 46 installing a hard drive – HP D2D100 Backup System User Manual

Page 119

NOTE:

If the replacement drive is not supplied with screws, remove the screws (two on each side) from the

failed drive.

Figure 45 Removing the hard drive

10.

Replace the failed disk with the new disk.
Insert the four drive screws (two on each side) into the hard drive (1). If these are not supplied with

the new disk, use the screws from the failed disk. Slide the new hard drive (2) into the selected bay

until it clicks into place. Connect the power cable from the power supply to the back of the hard

drive and plug in the SATA cable (3).

Figure 46 Installing a hard drive

11.

Replace the drive cover.
a. Replace the cover.
b. Use the screw removed in step 7 to secure it.

D2D Backup System

119