49 replacing the access panel – HP D2D100 Backup System User Manual

Page 121

Figure 49 Replacing the access panel

14.

Reconnect the network cable and the power cord.

15.

Power up again by pressing the Power on switch on the front of the unit.

16.

You now need to rebuild the RAID array. Select Disk & RAID on the Web Management interface.

17.

The status of the failed disk should now be OK and there is a message to say that the disk is

available but not yet part of the RAID system. Click Add Disk to add the disk to the RAID array. The

screen refreshes and a rebuilding status message is displayed against the RAID State.

D2D Backup System

121