HP D2D100 Backup System - Manual (Page 36)

Figure 22 Replacing the bezel
3. Use two hands to place the access panel flat against the chassis (1), the back of the access panel
extending about 2.5 cm (1.0 in) behind the back of the server. Make sure the hooks on the access
panel align with the holes on the edges of the chassis. Slide (2) the access panel toward the front of
the chassis to position it into place. Tighten the captive thumbscrew (3) to secure the access panel.
Figure 23 Replacing the access panel
4. Reconnect the network cable and the power cord.
Connecting an external tape drive
Read this section if your are connecting an external tape drive.
NOTE:
You can only connect an external tape drive, if you have already installed a recommended HBA.
1. Connect the device cable (SCSI or SAS) to the appropriate ports on the HBA and tape drive. The
example shows a SCSI tape drive.
2. Plug the power cable (1)ecurely into the socket on the rear panel of the drive and plug the other end
of the power cable into the power outlet. The power on/off switch (2)is on the front panel.
36 Attaching a physical tape drive (optional)