Hp storage san visibility package contents, Hardware and software requirements, Viewing report – HP SAN User Manual
Page 7

This chapter addresses the following topics:
•
“HP Storage SAN Visibility package contents” (page 7)
•
“Hardware and software requirements” (page 7)
HP Storage SAN Visibility package contents
Following are the components of the HP Storage SAN Visibility bundle:
•
HP Storage SAN Visibility installer (SANVisibility_Setup.exe)
•
Product documentation
•
Licenses
Hardware and software requirements
This section discusses the hardware and software requirements for installing HP Storage SAN
Visibility.
•
Software
To use HP Storage SAN Visibility, following are the necessary applications that need to be
installed on a host where HP Storage SAN Visibility is installed:
Installation
◦
Java 2 Runtime Environment (JRE) v1.5 or v1.6.
Data Collection
◦
Windows Remote Management version 2.0 (WinRM)
Run following commands to complete the winrm setup
1.
Open command prompt.
2.
Execute winrm quickconfig
–
If the system prompts to start the WinRM service, press 'y' followed by the
'enter'
3.
Execute “winrm set winrm/config/Service/auth @{Basic="true"}”
4.
Execute “winrm set winrm/config/Service
@{AllowUnencrypted="true"}”
–
Brocade SMI Agent (120.6.0 a) installed for SMI-S based data collection. For
more information, see the SMI-Agent user guide.
NOTE:
Brocade SMI-Agent installation is not mandatory for SAN Visibility data collection. If
Brocade SMI-Agent is not installed, then the collection takes place through SNMP (and Brocade
APIs). For more information on data collection methods, see
“Data collection methods” (page 37)
.
Viewing Report
•
Internet Explorer 8 or Internet Explorer 9
•
Microsoft Excel viewer
•
Microsoft Visio viewer
lists the hardware requirements.
HP Storage SAN Visibility package contents
7