HP DL380z Gen8 Virtual Workstation User Manual
Hp dl380z gen8 virtual workstation
Table of contents
Document Outline
- Abstract
- Component identification
- Front panel components
- Front panel LEDs and buttons
- Access the Systems Insight Display
- Systems Insight Display LEDs
- Systems Insight Display LED combinations
- Rear panel components
- Rear panel LEDs and buttons
- Non-hot-plug PCI riser board slot definitions
- System board components
- SAS and SATA device numbers
- Hot-plug drive LED definitions
- PCI riser cage LED
- FBWC module LEDs (P420)
- Hot-plug fans
- Operations
- Power up the server
- Power down the server
- Extend the server from the rack
- Remove the access panel
- Install the access panel
- Access the product rear panel
- Remove the hot-plug fan cage
- Remove the hot-plug fan
- Remove the full-length expansion board
- Remove the PCI riser cage
- Install the PCI riser cage
- Secure the full-length expansion board retainer
- Remove the air baffle
- Setup
- Hardware options installation
- Introduction
- Memory options
- Hot-plug hard drive options
- Controller options
- Optical drive option
- 48V DC power supply option
- FlexibleLOM option
- Expansion board options
- Secondary PCI riser cage option
- 2U rack bezel option
- HP Trusted Platform Module option
- Cabling
- Software and configuration utilities
- Troubleshooting
- Battery replacement
- Specifications
- Support and other resources
- Acronyms and abbreviations
- Documentation feedback
- Index