HP DL380z Gen8 Virtual Workstation - Manual (Page 76)

● When returning a system board for service replacement, do not remove the TPM from the
system board. When requested, HP Service provides a TPM with the spare system board.
● Any attempt to remove an installed TPM from the system board breaks or disfigures the TPM
security rivet. Upon locating a broken or disfigured rivet on an installed TPM, administrators
should consider the system compromised and take appropriate measures to ensure the integrity
of the system data.
● HP is not liable for blocked data access caused by improper TPM use. For operating
instructions, see the encryption technology feature documentation provided by the operating
system.
Installing the Trusted Platform Module board
WARNING! To reduce the risk of personal injury, electric shock, or damage to the equipment,
remove the power cord to remove power from the server. The front panel Power On/Standby button
does not completely shut off system power. Portions of the power supply and some internal circuitry
remain active until AC power is removed.
WARNING! To reduce the risk of personal injury from hot surfaces, allow the drives and the internal
system components to cool before touching them.
1. Power down the server on page 18
2. Remove all power:
a.
Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Remove the server from the rack, if necessary.
4. Place the server on a flat, level work surface.
5. Remove the access panel on page 20
6. Remove the PCI riser cage on page 25
7. Remove the air baffle on page 28
CAUTION: Any attempt to remove an installed TPM from the system board breaks or
disfigures the TPM security rivet. Upon locating a broken or disfigured rivet on an installed TPM,
administrators should consider the system compromised and take appropriate measures to
ensure the integrity of the system data.
70 Chapter 5 Hardware options installation