HP DL380z Gen8 Virtual Workstation - Manual (Page 32)

Install the PCI riser cage
WARNING! To reduce the risk of personal injury, electric shock, or damage to the equipment,
remove the power cord to remove power from the server. The front panel Power On/Standby button
does not completely shut off system power. Portions of the power supply and some internal circuitry
remain active until AC power is removed.
1. Power down the server on page 18
2. Remove all power:
a.
Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Extend ( Extend the server from the rack on page 19 ) or remove the server from the rack.
4. Remove the access panel on page 20
5. Install the PCI riser cage.
6. Install the access panel on page 20 .
7. Install the server into the rack ("Installing the server into the rack" on page 37).
8. Connect each power cord to the server.
9. Connect each power cord to the power source.
10. Power down the server on page 18 .
26 Chapter 3 Operations