HP DL380z Gen8 Virtual Workstation - Manual (Page 94)

Re-entering the server serial number and product ID
After you replace the system board, you must re-enter the server serial number and the product ID.
1. During the server startup sequence, press the F9 key to access RBSU.
2. Select the Advanced Options menu.
3. Select Service Options.
4. Select Serial Number. The following warnings appear:
WARNING! The serial number is loaded into the system during the manufacturing process and
should NOT be modified. This option should only be used by qualified service personnel. This
value should always match the serial number sticker located on the chassis.
The serial number should ONLY be modified by qualified service personnel. This value should
always match the serial number located on the chassis.
5. Press the Enter key to clear the warning.
6. Enter the serial number and press the Enter key.
7. Select Product ID. The following warning appears:
WARNING! The Product ID should ONLY be modified by qualified service personnel. This
value should always match the Product ID on the chassis.
8. Enter the product ID and press the Enter key.
9. Press the Esc key to close the menu.
10. Press the Esc key to exit RBSU.
11. Press the F10 key to confirm exiting RBSU. The server automatically reboots.
Utilities and features
Array Configuration Utility
ACU is a utility with the following features:
● Runs as a local application or remote service accessed through the HP System Management
Homepage
● Supports online array capacity expansion, logical drive extension, assignment of online spares,
and RAID or stripe size migration
● Suggests the optimum configuration for an unconfigured system
● For supported controllers, provides access to licensed features, including:
◦ Moving and deleting individual logical volumes
◦ Advanced Capacity Expansion (SATA to SAS and SAS to SATA)
◦ Offline Split Mirror
◦ RAID 6 and RAID 60
◦ RAID 1 (ADM) and RAID 10 (ADM)
88 Chapter 7 Software and configuration utilities