HP DL380z Gen8 Virtual Workstation - Manual (Page 26)

Remove the access panel
WARNING! To reduce the risk of personal injury from hot surfaces, allow the drives and the internal
system components to cool before touching them.
CAUTION: Do not operate the server for long periods with the access panel open or removed.
Operating the server in this manner results in improper airflow and improper cooling that can lead to
thermal damage.
To remove the component:
1. Power down the server on page 18 .
2. Extend the server from the rack on page 19 .
3. Open or unlock the locking latch, slide the access panel to the rear of the chassis, and remove
the access panel.
Install the access panel
1. Place the access panel on top of the server with the hood latch open. Allow the panel to extend
past the rear of the server approximately 1.25 cm (0.5 in).
2. Push down on the hood latch. The access panel slides to a closed position.
3. Tighten the security screw on the hood latch.
20 Chapter 3 Operations