Powering on and selecting boot options, Registering the server – HP DL380z Gen8 Virtual Workstation User Manual
Page 44

Powering on and selecting boot options
1.
Connect the Ethernet cable.
2.
Press the Power On/Standby button.
3.
During the initial boot:
●
To modify the server configuration ROM default settings, press
F9
when prompted from the
start up sequence to enter the RBSU. By default, RBSU runs in the English language.
●
If you do not need to modify the server configuration and are ready to install the system
software, press
F10
to access Intelligent Provisioning.
NOTE:
If an HP Smart Array controller has been added or is embedded in the system, the
controller defaults to a RAID configuration based on the size and number of hard drives
installed. For more information on modifying the controller default settings, see the
documentation on the Documentation CD.
For more information on automatic configuration, see the HP ROM-Based Setup Utility User Guide on
Registering the server
To experience quicker service and more efficient support, register the product at the HP Product
38 Chapter 4 Setup