Brother HL-2170W - Manual (Page 301)

CHAPTER 6 EPSON - 13
Enable out-of-paper sensor
Esc9 (27)(57) <1Bh><39h>
The printer ignores this command.
Disable out-of-paper sensor
Esc8 (27)(56) <1Bh><38h>
The printer ignores this command.
6.2.
Page set up
Set page length
EscCn (27)(67)n <1Bh><43h>n
This command sets the page length in lines.
or
EscCNULn (27)(67)(00)n <1Bh><43h><00h>n
 This command sets the page length in inches.
 The top of form position is set to be the current line.
 n is the number of lines that make up one page, or the length of the page in inches, according to which form
of the command is used.
 If the first form of the command is used (n = the number of lines in the page) the current line spacing setting
is used to determine the length of the page.
 If the first form of the command is used, n must be in the range 1 to 127.
 If the second form of the command is used (n = page length in inches), n must be in the range 1 to 14.
LPRINT CHR$(27); CHR$(67); CHR$(40); '40 lines per page
LPRINT CHR$(27); CHR$(67); CHR$(0); CHR$(11); '11 inches per page
Set left margin
Escln (27)(108)n <1Bh><6Ch>n
 This command sets the left margin in columns from the left edge of the page. The width of a column is the
current character width.
 In proportional spacing mode a column width of 1/10" is adopted.
 This command clears all tab settings.
 The minimum space allowed between the left and right margins is 1/5".
LPRINT CHR$(27); CHR$(108); CHR$(10); 'Left margin 1" at 10 cpi
Set right margin
EscQn (27)(81)n <1Bh><51h>n
 This command sets the right margin in columns from the left edge of the page. The width of a column is the
current character width.
 In proportional spacing mode a column width of 1/10" is adopted.
 This command clears all tab settings.
 The minimum space allowed between the left and right margins is 1/5".
LPRINT CHR$(27); CHR$(81); CHR$(72); 'Right margin 6" at 12 cpi
Set perforation skip
EscNn (27)(78)n <1Bh><4Eh>n
 This command sets the bottom margin and enables perforation skip, that is, whenever the print position
reaches the bottom margin the printer performs a page eject and moves the print position to the top of the
next page.
 n = the number of lines at the current line spacing setting between the bottom margin and the bottom edge of
the paper.
 n must be in the range 1 to 127.
 Esc C (Set Page Length) and Esc O (Cancel Perforation Skip) cancel automatic perforation skip.