NORD Drivesystems BU0220 - Manual (Page 49)

5 Parameterisation
BU 0220 GB-0912 Subject to technical amendments 49
Parameter Setting value / Description / Note Device Supervisor
Parameter
set
P741 ... [-01]
...
... [-10]
Process data bus Out S
0000 ... FFFF (hex) This parameter provides information about the actual status word and the actual values that are
transferred via the bus systems.
... [-01] = Status word Status word
... [-02] = Actual value 1 (P543 [-01])
... [-03] = Actual value 2 (P543 [-02])
... [-04] = Actual value 3 (P543 [-03])
... [-05] = Bus I/O Out Bit (P481) The displayed value depicts all Bus Out Bit sources
linked with or.
... [-06] = Parameter data Out 1
... [-07] = Parameter data Out 2
... [-08] = Parameter data Out 3
... [-09] = Parameter data Out 4
... [-10] = Parameter data Out 5
Data during parameter transfer.
P748 System bus status
0000 ... FFFF (hex)
or
0 ... 65535 (dec)
Shows the status of the system bus.
Bit 0:
Bit 1:
Bit 2:
Bit 3:
Bit 4:
Bit 5:
Bit 6:
Bit 7:
Bit 8:
Bit 9:
Bit 10:
24V Bus supply voltage
CANbus in "Bus Warning" status
CANbus in "Bus Off" status
Bus module is online
Additional module 1 is online
Additional module 2 is online
The protocol of the CAN module is 0 = CAN / 1 = CANopen
Vacant
"Bootup Message" sent
CANopen NMT State
CANopen NMT State
CANopen NMT State Bit 10 Bit 9
Stopped
Pre-Operational
Operational 0
0
1 0
1
0
P749 DIP switch status
0000 ... 01FF (hex)
or
0 ... 511 (dec)
This parameter shows the actual setting of the FI DIP switch "S1" (See BU0200).
Bit 0:
Bit 1:
Bit 2:
Bit 3:
Bit 4:
DIP switch 1
DIP switch 2
DIP switch 3
DIP switch 4
DIP switch 5
Bit 5:
Bit 6:
Bit 7:
Bit 8:
DIP switch 6
DIP switch 7
DIP switch 8
EEPROM – Memory module
(0=plugged in, 1= not plugged in)