Milestone Smart Client 3.6 - Manual (Page 79)

Milestone XProtect Smart Client 3.6; User’s Manual
Alerts
Note: The Alerts section is used for slightly different purposes, depending on which type of
Milestone surveillance system you connect to; see Surveillance System Differences on page 100 for
details. Consult your surveillance system administrator if in doubt.
If You Are Connected to a Milestone XProtect Corporate
Surveillance System
The Browse tab's Alerts section lets you view a list of detected alerts.
Alerts are short messages customized to suit your organization's needs. Examples of alerts: Panic
Button Pressed, Fire Exit 23 Open, Employee Clocking In, etc.
Alerts may be triggered for a variety of reasons; they are not necessarily related to system events,
although that may often be the case.
Listed alerts are clickable, allowing you to quickly jump to the time at which an alert occurred.
To get a list of alerts, do the following:
1. Select the required alert in the Alerts list.
2. Click the Get List button. This will display a list of
detected alerts.
You are able to click the listed alerts to view
recordings from the required alert in the view.
Tip: To view what took place prior to and after the
alert, use the Time Navigation controls to browse
recordings from around the time of the alert.
If You Are Connected to a Milestone XProtect Enterprise, XProtect
Professional or XProtect Basis+ Surveillance System
The Browse tab’s Alerts section lets you view a list of
detected events (occasionally known as alerts).
Listed events are clickable, allowing you to quickly jump
to the time at which an event occurred.
To get a list of events, do the following:
1. Select the required events in the Alerts list.
You may either select a single event:
Or all events on a particular camera:
www.milestonesys.com Page 79 Viewing Recorded Video