Badger Meter SRD/SRI Valve Positioners - Manual (Page 92)

Analog Setpoint High
This is a 4-byte real and defines the maximum value of the analog setpoint . It is normally set at the factory to 4 .0 mA, but can
be adjusted higher for split ranging . If the positioner is being used in the analog mode, the calibration by Analog Setpoint
feature is available in the Calibrate menu . The Analog Setpoint feature is also available in the push button menu of the
positioner’s PCB .
Fabrication Number
This is a 4-byte number that is pre-set at the factory .
Hardware Revision
This single byte field is pre-set at the factory to show the revision of the electronics within the positioner .
Simulation Value
If simulation of an SRD991 position is enabled, this simulated value is sent back to the I/A system instead of the actual
potentiometer reading .
Additional Status
Page 92 August 2014 POS-UM-00011-EN-02