KROHNE MAC 100 EN - Manual (Page 59)

OPERATION
6
59
OPTISENS MAC 100
www.krohne.com 04/2011 - MA OPTISENS MAC 100 R01 en
6.5.4 Menu D, service
This menu is password protected and contains functions to be used by service personnel only.
C5.7 C5.7 C5.7 C5.7 units This menu groups several functions to define the units of the measuring
results. These unit are used for all values of the related unit group on the
display (measuring screen and parameters).
C5.7.1 concentration absolute This function allows to define the absolute concentration unit used for
amperometric measurements.
Options: mg/l, µg/l, ppm (parts per million), ppb (parts per billion), free unit.
C5.7.2 Text free unit This function allows to define a text if a free unit was chosen for the absolute
concentration (see previous function C5.7.1).
Conditions: at most three characters before and three after the slash!
C5.7.3 [g/l]*factor This function allows to define the conversion factor if a free unit was chosen
for the absolute concentration (see previous function C5.7.1). With this factor
the measurement value in g/l is multiplied to get a value in the free unit.
C5.7.4 rel. concentration DO This function allows to define the relative concentration unit used for the
measurement of DO (dissolved oxygen).
Options: %, ppm (parts per million), ppb (parts per billion).
C5.7.5 conc.solution This function allows to define the concentration unit used for solution
measurement.
Options: %, ppm (parts per million), ppb (parts per billion).
C5.7.6 spec.conductivity This function allows to define the specific conductivity unit.
Options: mS/cm, µS/cm, free unit.
C5.7.7 Text free unit Properties comply with C5.7.2.
C5.7.8 [S/m]*factor Properties comply with C5.7.3 except that the measurement value is [S/m].
C5.7.9 spec.resistance This function allows to define the specific resistance unit.
Options: MOhm x cm, free unit.
C5.7.10 Text free unit Properties comply with C5.7.2.
C5.7.11 [Ohm x m]*factor Properties comply with C5.7.3 except that the measurement value is
[Ohm/m].
C5.7.12 temperature This function allows to define the temperature unit.
Options: °C, °F, K.
C5.7.13 air pressure This function allows to define the air pressure unit.
Options: Pa, kPa, bar, mbar, Torr, atm.
C5.7.14 probe current This function allows to define the probe current unit.
Options: mA, free unit.
C5.7.15 Text free unit Properties comply with C5.7.2.
C5.7.16 [A]*factor Properties comply with C5.7.3 except that the measurement value is [A].
Level Designation / function Settings / descriptions
.book Page 59 Friday, April 1, 2011 4:59 PM