KROHNE MAC 100 EN - Manual (Page 50)

6
OPERATION
50
OPTISENS MAC 100
www.krohne.com 04/2011 - MA OPTISENS MAC 100 R01 en
6.5 Function tables
6.5.1 Menu A, quick setup
A1, language
A2, tag
A3, manual hold
A4, set clock
A5, reset errors
INFORMATION!
Note that the appearance of some sub-menus depends on the hardware setting and the used
sensor(s). E.g. if you use a pH sensor then only the menu A8 with the name "process input A
pH calibration" appears.
Language selection (depends on the region for which the converter has been ordered). Available languages: German,
English.
Measuring point identifier (Tag no.), helps to identify the device in a plant, appears in the LC display header in the
normal measuring mode (up to 8 digits).
Manual shift into the simulation mode for maintenance; device aborts measuring and holds all analog measurements
from the process inputs. Options: On (enter the simulation mode) / Off (enter the normal measuring mode again.)
Manual setting of date and time.
This functions allows to reset all errors that are not reset automatically (e.g. power fail or counter overflow). You can
answer the question "reset?" with the following options: no (exit without reset) / yes (reset and exit the function).
.book Page 50 Friday, April 1, 2011 4:59 PM