KROHNE MAC 100 EN - Manual (Page 48)

6
OPERATION
48
OPTISENS MAC 100
www.krohne.com 04/2011 - MA OPTISENS MAC 100 R01 en
Measuring
mode Main menu Submenu Parameter
3 or 4
pages,
scrolling
with ↓ or ↑
> 2.5 s
^
B test B test B test B test >
^
B3 simulation IO >
^
B3.1 - / current output A >
^
For further
information
see function
tables.
B3.2 - / current output B
B3.3 - / current output C
B3.4 - / control input D
B3.5 - / status output R1 or limit
switch R1
B3.6 - / status output R2 or limit
switch R2
B3.7 - / status output R3 or limit
switch R3
B4 actual values B4.1...B4.8: menus which show
the corresponding actual
reading; existence of the single
sub-menus depends on the
hardware setting and the used
sensor; refer to sensor manual
for further information.
B5 logbooks B5.1 status log
B5.2 calibration log
B6 information B6.1 C number
B6.2 process input A
B6.3 process input B
B6.4 SW.REV. MS
B6.5 SW.REV. UIS
B6 Electronic Revision ER
↓↑ ↓↑ ↓↑ ↓↑
> 2.5 s
^
C setup C setup C setup C setup >
^
C1 process input
A
>
^
C1.1...C1.18: menus for the
setup of the corresponding
process input; existence of the
single sub-menus depends on
the hardware setting and the
used sensor; refer to sensor
manual for further information.
>
^
C2 process input
B
C2.1...C2.17: menus for the
setup of the corresponding
process input; existence of the
single sub-menus depends on
the hardware setting and the
used sensor; refer to sensor
manual for further information.
↓↑ ↓↑ ↓↑ ↓↑
.book Page 48 Friday, April 1, 2011 4:59 PM