KROHNE MAC 100 EN - Manual (Page 30)

4
ELECTRICAL CONNECTIONS
30
OPTISENS MAC 100
www.krohne.com 04/2011 - MA OPTISENS MAC 100 R01 en
4.10 Electrical connection of the outputs and the input
• Open the housing cover ( refer to Opening the converter housing on page 22).
• Push the prepared cables through the cable entries and connect the necessary conductors.
• Connect the shield.
• Tighten the screw connection of the cable entry securely.
• Seal all cable entries that are not needed with a plug.
• Close the housing cover.
4.10.1 Connecting the current outputs
• Conduct the cables with prefabricated shielding through the correct cable glands (1 and 2).
• Insert the cable into the terminal (3).
• To remove the cable push the lever down with a suitable tool (4) and pull the cable out of the
terminal (5).
DANGER!
All work on the electrical connections may only be carried out with the power disconnected. Take
note of the voltage data on the nameplate!
INFORMATION!
Assembly materials and tools are not part of the delivery. Use the assembly materials and tools
in compliance with the applicable occupational health and safety directives.
INFORMATION!
Ensure that the housing gasket is properly fitted, clean and undamaged.
CAUTION!
Use the correct cable gland, refer to the following drawing and to the section
"device description" in the manual.refer to the device description on page 30.
.book Page 30 Friday, April 1, 2011 4:59 PM