KROHNE MAC 100 EN - Manual (Page 47)

OPERATION
6
47
OPTISENS MAC 100
www.krohne.com 04/2011 - MA OPTISENS MAC 100 R01 en
6.4 Menu mode structure
INFORMATION!
The following table just presents an overview. When programming the device, always consult the
function tables additionally as they contain further information!
Measuring
mode Main menu Submenu Parameter
3 or 4
pages,
scrolling
with ↓ or ↑
> 2.5 s
^
A quick setup A quick setup A quick setup A quick setup >
^
A1 language >
^
For further
information
see function
tables.
A2 Tag
A3 manual hold
A4 set clock
A5 reset errors
A6 analog
outputs
>
^
A6.1 measurement
A6.2 unit
A6.3 range
A6.4 time constant
A9...A11: calibration menus for process input A;
existence of the single sub-menus depends on the
hardware setting and the used sensor (e.g. if you use a
pH sensor then only the menu A8 with the name "pH
cal." appears); refer to sensor manual for further
information.
A12...A16: calibration sub-menus for process input B,
existence also depending on the hardware setting and
the used sensor.
↓↑ ↓↑ ↓↑ ↓↑
> 2.5 s
^
B test B test B test B test >
^
B1 Simulation
Process Input A
>
^
B1.1...B1.7: simulation menus
for process input A; existence of
the single sub-menus depends
on the hardware setting and the
used sensor, refer to sensor
manual for further information.
>
^
For further
information
see function
tables.
B2 Simulation
Process Input B
B2.1...B2.7: simulation menus
for process input B; existence of
the single sub-menus depends
on the hardware setting and the
used sensor, refer to sensor
manual for further information.
↓↑ ↓↑ ↓↑ ↓↑
.book Page 47 Friday, April 1, 2011 4:59 PM