KROHNE MAC 100 EN - Manual (Page 56)

6
OPERATION
56
OPTISENS MAC 100
www.krohne.com 04/2011 - MA OPTISENS MAC 100 R01 en
C3.5.3 information Contains serial number, software version number and production date of the
circuit board.
C3.5.4 simulation This function allows to simulate input values for the control input. For
further information refer to Menu B, test on page 52and refer to Simulation
of measured values on page 60.
C3.6 C3.6 C3.6 C3.6 status output R1 or limit
switch R1
Fine adjustment of the corresponding status output or limit switch; the
function of the following sub-menus depend on the hardware setting.
C3.6.1 "mode" (status output) or
"measurement" (limit
switch)
Status output: this function allows to select the mode; note that the following
option list can be reduced depending on the available functions; for further
information about the messages refer to Status messages and diagnostic
information on page 66). Options:
• application error: output is activated if the errors "F F F F error in device" or "F
application error" emerge
• out of specification: output is activated if the errors "F F F F error in device" or
"F application error" emerge, it is also activated if a warning of the
category "out of specification" is present
• control input: signal from control input is forwarded to the status output
• off: status output deactivated
• error in device: output is activated if the error "F F F F error in device" emerges
Limit switch: this function allows to define the value which activates the limit
switch. The available options depend on the hardware setting and the kind of
the sensor used, refer to the sensor manual for further information.
C3.6.2 "invert signal" (status
output) or "threshold"
(limit switch)
Status output: this function allows to define how the status output is
activated. Options: off (activated status output generates a high current) /
on (activated output generates a low current).
Limit switch: this function allows to define the switching level. The first
value defines the level, the second level defines a hysteresis.
C3.6.3 "information" (status
output) or "time constant"
(limit switch)
Status output: contains serial number, software version number and
production date of the circuit board.
Limit switch: filter for limit switch.
C3.6.4 "simulation" (status
output) or "invert signal"
(limit switch)
This function allows to simulate the status of the corresponding status input.
For further information refer to Menu B, test on page 52and refer to
Simulation of measured values on page 60.
Limit switch: this function allows to define how the limit switch is activated.
Options: off (exceeded limit generates a high current at the output) /
on (exceeded limit generates a low current at the output).
C3.6.5 information Only available for limit switch; contains serial number, software version
number and production date of the circuit board.
C3.6.6 simulation This function allows to simulate the status for the corresponding limit
switch. For further information refer to Menu B, test on page 52and refer to
Simulation of measured values on page 60.
C3.7 C3.7 C3.7 C3.7 status output R2 or limit
switch R2
Refer to submenus of status output or limit switch R1 (all submenus and
options are identical, except that they start with C3.7).
C3.8 C3.8 C3.8 C3.8 status output R2 or limit
switch R2
Refer to submenus of status output or limit switch R1 (all submenus and
options are identical, except that they start with C3.8).
Level Designation / function Settings / descriptions
.book Page 56 Friday, April 1, 2011 4:59 PM