KEPCO ATE-DMG SERIES - Manual (Page 92)

B-22 ATE-DMG 042314
B.91 SYSTem:PASSword:CENable COMMAND 
SYST:PASS:CEN
Syntax: Short Form: SYST:PASS:CEN Long Form: SYSTem:PASSword:CENable
Description: Sets the password enable state if the value matches the current password. This command allows
other commands such as *SAV 41 to operate.
B.92 SYSTem:PASSword:CDISable COMMAND 
SYST:PASS:CDIS
Syntax: Short Form: SYST:PASS:CDIS Long Form: SYSTem:PASSword:CDISable
Description: Clears the password enable state if the value matches the current password.
B.93 SYSTem:PASSword:STATe? QUERY 
SYST:PASS:STAT?
Syntax: Short Form: SYST:PASS:STAT? Long Form: SYSTem:PASSword:STATe?
Return Value: 0 or 1
Description: Returns a 1 if the password state is enabled or a 0 if it is disabled.
B.94 SYSTem:SECurity:IMMediate COMMAND 
SYST:SEC:IMM
Syntax: Short Form: SYST:SEC:IMM Long Form: SYSTem:SECurity:IMMediate
Description: Initializes all NVRAM variable to factory defaults. This includes all memory steps to be set to 0 volts,
1.28% of full scale current, overvoltage and overcurrent to be set to Iomax+10%, time value to be set
to 0, and next step equal to 0.).It also initializes the power -up state to have DC Output Control off (see
DCL Control, PAR 3.5.2). The calibration password is reset per Table B-5. Use master password (see
below, Table B-6) If password has been lost. Related Commands: SYST:PASS:CEN must be sent
prior to this command
.
TABLE B-5. FACTORY DEFAULT CALIBRATION PASSWORDS
MODEL PASSWORD
ATE 6-100DMG 6100
ATE 15-50DMG 1550
ATE 25-40DMG 2540
ATE 36-30DMG 3630
ATE 55-20DMG 5520
ATE 75-15DMG 7515
ATE 100-10DMG 1001
ATE 150-7DMG 1507
TABLE B-6. MASTER PASSWORDS
MODEL PASSWORD MODEL PASSWORD MODEL PASSWORD
ATE 6-
100DMG
..17
ATE 36-
30DM
..44
ATE 100-
10DMG
..78
ATE 15-
50DMG
..26
ATE 55-
20DMG
..52
ATE 150-
7DMG
..86
ATE 25-
40DMG
..35
ATE 75-
15DMG
..69