In-Situ Win-Situ 4 / Pocket-Situ 4 Operators Manual - Manual (Page 79)

79 SECTION 11: FLOW-SENSE WIZARD
rev. 003 11/04
Verify Unit Preferences
Before the Flow-Sense Wizard starts, you may wish to verify the current
unit selections. Length measurements in the Flow-Sense Wizard default to
metric (meters, centimeters), but you can enter and display this data in
English units (feet, inches) if you prefer. You may also wish to verify the
units for Conductivity, Dissolved Oxygen, ORP, pH, Temperature, and
Turbidity.
To skip the settings verification, click Continue.
The Wizard will open the COM port and connect to the instrument. If you
have used the Wizard before, or launched the Wizard from an existing .flo
file, data entry values will be supplied.
TIP: Flow units in
the Flow-Sense
Wizard will
always be in milliliters (mL).
For best results, units
should be consistent
between the desktop
application and the PDA
application.
TIP: The Wizard
opens the COM
port you used
last (this is stored in the
Wizards.ini file in the Config
subfolder in the folder
where Win-Situ is installed).
If several connections have
been used in the past, the
Wizard uses the first “direct”
connection it encounters in
the tree.
If the Wizard is started
without any connection
information, at all, it will
attempt to connect using
COM 1 at a baud rate of
19200.