In-Situ Win-Situ 4 / Pocket-Situ 4 Operators Manual - Manual (Page 41)

41
0031510 rev. 003 11/04
SECTION 7: PROFILING
• Readings are updated approximately every 2 seconds (default), or
whatever interval you may have specified when setting up preferences.
• The current measurement unit is shown below each reading.
• A window without a reading indicates the channel is not available to
read, usually because there is no sensor installed in the port.
TIP: To change
unit preferences:
Close the Profiler.
In Win-Situ, select
Preferences on the Options
menu. In Pocket-Situ,
select the Home site, then
tap Setup... in the
command bar.
Close the Profiler and return
to the Parameter display
Display a graph of the data,
starting with the first channel
Log next set of
readings to the Data
Folder on the PC
Log continuously updated
readings to the Data
Folder on the PC.
Changes to “Stop Log”
during continuous logging.
Select a different
channel for display in
this position
Profiler logging status
Click any reading to
see a graph of the
channel