Edwards Signaling FireShield 10 Zone - Manual (Page 31)

Programming
FireShield Technical Reference Manual 3.9
Programming the FSDACT
When you program the FSDACT, you’ll follow these general
steps:
1. Enter your passcode
2. Load default settings
3. Edit
your passcode
4. Enter the date
5. Enter the time
6. Select the FSDACT mode
7. Enter the (DACR1) primary phone number
8. Enter the (DACR1) secondary phone number
9. Enter the (DACR1) account code
10. Select the DACR1 alarm format
11. Select the restore option for CMS one
12. Enter retry count one
13. Enter retry time one
14. Enter the (DACR2) primary phone number
15. Enter the (DACR2) secondary phone number
16. Enter the (DACR2) account code
17. Select the DACR2 alarm format
18. Select the restore option for CMS two
19. Enter retry count two
20. Enter retry time two
21. Select tone or pulse dialing
22. Select AC fail delay time
23. Enter the transmission test time
24. Select the transmission test frequency
25. Enter the number of rings to answer
26. Select the ring type
27. Enable (disable) call back
28. Enter the call back phone number
Tip: If you save an incorrect digit, press Walk Test then
Remote Disconnect. This returns the cursor to the first digit.
Press Panel Silence until the cursor is at the incorrect digit.
Enter the correct digit, then press Panel Silence to save and
advance to the next digit.
1. Enter your passcode
Description: Access to dialer programming is passcode
restricted. For security, the default passcode should be
changed as part of the installation. (To change the passcode,
refer to “Edit passcode,” below.)
Format: 7 digits
Default: 1111111
To enter your passcode:
1. Press Reset (or Signal Silence & Drill) to scroll through
the setting list until the first digit of your passcode is
displayed.
2. Press Panel Silence to save and advance to the next digit.
The trouble buzzer sounds a long beep as confirmation.
3. Press Reset (or Signal Silence & Drill) until the next digit
of your passcode is displayed.
4. Press Panel Silence to save and advance to the next digit.
5. Repeat steps 3 and 4 until all digits are entered.
6. When you press Reset at the last digit, the system
automatically advances you to the next program option.
2. Load default settings
Description: Loads the factory default settings for each
program option.
Settings: Yes = Loads the default settings
No = Does not load the default settings
Default: No
To load default settings:
1. Press Reset to select Yes or No.
2. Press Panel Silence to save and advance to the next
program option.
The trouble buzzer sounds a long beep as confirmation.
3. Edit your passcode
Description: You have the option to change your passcode or
continue with programming.
Format: 7 digits
Default: No default
To skip changing your passcode:
1. Press Remote Disconnect to advance to the next program
option.
To change your passcode:
1. Press Reset until the first digit of your new passcode is
displayed.
2. Press Panel Silence to save and advance to the next digit.
The trouble buzzer sounds a long beep as confirmation.
3. Press Reset until the next digit is displayed.
4. Press Panel Silence to save and advance to the next digit.
5. Repeat steps 3 and 4 until all digits are entered.
6. When you press Panel Silence at the last digit, the system
automatically advances you to the next program option.
4. Enter the date
Description: Sets the current date.
Format: MMDDYYYY
Default: 01012002