Spectra Precision Survey Pro CE v3.60 GPS User Manual - Manual (Page 57)

RTK Data Collection
53
¾ Occupying a point on line with the reference point and
the offset point. After you occupy the reference point,
tap
'LUHFWLRQ IURP 7ZR 3RLQWV and then occupy a point
on line with the reference point and the offset point.
When you are done occupying the on line point, you
will be prompted for the direction to your offset point.
¾ Entering a value by hand.
8. Tap
6WRUH to store the point.
9. Store any number of additional offset points from this GPS
reference point. The shot data for each point is recorded in .RAW
data. Tap
&ORVH when you are done storing points.
Feature Collection
Use this method if you want to collect multiple points using either a
measurement interval or by manually accepting each point. You can
select from five different data collection modes.
1. Go to Data Collection from the Survey menu.
2. Enter a point name in the Point field. If this point already exists,
you will be prompted to overwrite or choose the next available
point.
Note: If you have Store GPS Raw Data set to + Bl,CV or + Bl,CV + Rx
Raw, feature collection will not store base line records because there
is no discrete site occupation of each point. Therefore, the point name
does not need to be a valid Site Id.
3. Enter a Description.
Note: For continuous data collection (except Manual: multi
descriptions ), once the first point is accepted, all additional points will
be stored with the same description, layer, and attributes. When
using
Manual: multi descriptions mode, you will be prompted for
description, layer, and attributes (if set) after every point.